Global Services Forum Index
Author Message

<  Cirrus Products  ~  cirrus 4 channel receiver

fburmeister
Posted: Thu Nov 01, 2007 1:08 pm Reply with quote
New User New User
Joined: 12 Apr 2006 Posts: 3
originally installed in lazy e-bee. replacing fuselage and had to remove servos, etc. where can i find a pinout diagram to reconnect using esc and 2 servos?
View user's profile Send private message
Todd Nicholson
Posted: Thu Nov 01, 2007 4:36 pm Reply with quote
R/C Guru R/C Guru
Joined: 05 Dec 2002 Posts: 2634
Are you referring to the Cirrus MRX4-II? If so, channel numbers and pin layout are printed on the receiver shrink wrap. If that's been removed, check this photo:

http://www.hobbypeople.net/gallery/443534.asp

This view shows the channel layout as if looking at the bottom of the PC board. Pins are as follows (-) nearest the PC board, (+) in the middle and (S - signal) farthest from the PC board.

Hope this helps.

_________________
Regards,
Todd Nicholson

Global Services
18480 Bandilier Circle
Fountain Valley, CA 92708

EMail: service@globalhobby.net
View user's profile Send private message

Display posts from previous:  

All times are GMT - 7 Hours
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum